Siemens SINUMERIK 840D sl Operating Manual page 230

Tool management
10.5 Tool list
The tool creation sequence can be defined differently.
Unloading a tool in a file
According to the corresponding setting, the unloaded tool is deleted from the NC memory
after it has been read out.
Deleting a tool in a file
230
6. Press the "OK" softkey.
The tool is added to the tool list with the specified name. If the cursor is
located on an empty magazine location in the tool list, then the tool is
loaded to this magazine location.
1. The tool list is open.
2. Place the cursor on the tool that you would like to unload from the mag-
azine and press the "Unload" and "In file" softkeys.
3. Navigate to the required directory and press the "OK" softkey.
4. Enter the required file name in the "Name" field and press the "OK"
softkey.
The field is preassigned with tool names.
The tool is unloaded and the tool data is written to the file.
1. The tool list is open.
2. Position the cursor on the tool that you wish to delete.
3. Press the "Delete tool" and "In file" softkeys.
3. Navigate to the required directory and press the "OK" softkey.
4. Enter the required file name in the "Name" field and press the "OK"
softkey.
The field is preassigned with tool names.
The tool is unloaded and the tool data is written to the file. The tool is
then deleted from the NC memory.
Operating Manual, 01/2015, 6FC5398-6AP40-5BA2
Universal