6.8.2
Panning a graphical representation
Precondition
The simulation or the simultaneous recording is started.
Procedure
6.8.3
Rotating the graphical representation
In the 3D view you can rotate the position of the workpiece to view it from all sides.
Requirement
Simulation has been started and the 3D view is selected.
Procedure
...
...
Universal
Operating Manual, 01/2015, 6FC5398-6AP40-5BA2
1.
Press a cursor key if you wish to move the graphic up, down, left, or
right.
1.
Press the "Details" softkey.
2.
Press the "Rotate view" softkey.
3.
Press the "Arrow right", "Arrow left", "Arrow up", "Arrow down", "Arrow
clockwise" and "Arrow counterclockwise" softkeys to change the posi-
tion of the workpiece.
- OR -
Keep the <Shift> key pressed and then turn the workpiece in the desired
direction using the appropriate cursor keys.
6.8 Modifying and adapting the simulation graphics
Simulating machining
177