Additional Data - Siemens SINUMERIK 840D sl Operating Manual

10.5.2

Additional data

The following tool types require geometry data that is not included in the tool list display.
Tools with additional geometry data
Tool type
111 Conical ballhead cutter
121 End mill with corner round-
ing
130 Angle head cutter
131 Angle head cutter with
corner rounding
140 Face milling
155 Bevel cutter
156 Bevel cutter with corner
rounding
157 Conical die-milling cutter
585 Calibration tool
700 Slotting saw
710 3D-probe milling
712 Mono-probe
713 L-probe
714 Star-type probe
Universal
Operating Manual, 01/2015, 6FC5398-6AP40-5BA2
Additional parameters
Corner radius
Corner radius
Geometry length (length X, length Y, length Z)
Wear length (Δ length X, Δ length Y, Δ length Z)
Adapter length (length X, length Y, length Z)
V (direction vector 1 - 6)
Vector X, vector Y, vector Z
Geometry length (length X, length Y, length Z)
Corner radius
Wear length (Δ length X, Δ length Y, Δ length Z)
Adapter length (length X, length Y, length Z)
V (direction vector 1 - 6)
Vector X, vector Y, vector Z
External radius
Tool angle
Taper angle
Corner radius
Taper angle
Taper angle
Geometry length (length X, length Y, length Z)
Wear length (Δ length X, Δ length Y, Δ length Z)
Geometry length (length X, length Y, length Z)
Wear length (Δ length X, Δ length Y, Δ length Z)
Adapter length (length X, length Y, length Z)
Geometry (slot width, projection)
Wear (slot width, projection)
Geometry length (length X, length Y, length Z)
Wear length (Δ length X, Δ length Y, Δ length Z)
Geometry length (length X, length Y, length Z)
Wear length (Δ length X, Δ length Y, Δ length Z)
Geometry length (length X, length Y, length Z)
Wear length (Δ length X, Δ length Y, Δ length Z)
Boom length (length)
Geometry length (length X, length Y, length Z)
Wear length (Δ length X, Δ length Y, Δ length Z)
Outer diameter (∅)
Tool management
10.5 Tool list
221