Displaying The Zero Offset "Overview - Siemens SINUMERIK 840D sl Operating Manual

3.5.2

Displaying the zero offset "overview"

The active offsets or system offsets are displayed for all axes that have been the setup in the
"Work offset - overview" window.
In addition to the offset (course and fine), the associated rotation, scaling and mirroring are
also displayed.
This window is generally used only for monitoring.
Display of active work offsets
Work offsets
MCS actual value
Kin. trans. workpiece
Kin. trans. tool
DRF
$AA_OFF overlay
Basic reference
External WO frame
Total base WO
G500
Tool reference
Workpiece reference
Transformer reference
Programmed WO
Cycle reference
Total WO
T:
WCS actual value
Universal
Operating Manual, 01/2015, 6FC5398-6AP40-5BA2
Display of the actual value in the Machine Coordinate
System.
Displays the additional work offsets programmed with
$P_TRAFRAME_P.
Displays the additional work offsets programmed with
$P_TRAFRAME_T.
Displays the handwheel axis offset.
Displays the overlaid movement programmed with
$AA_OFF.
Displays the additional work offsets programmed with
$P_SETFRAME.
Access to the system offsets is protected via a keyswitch.
Displays the additional work offsets programmed with
$P_EXTFRAME.
Displays all effective basis offsets.
Displays the work offsets activated with G54 - G599.
Under certain circumstances, you can change the data
using "Set WO", i.e. you can correct a zero point that has
been set.
Displays the additional work offsets programmed with
$P_TOOLFRAME.
Displays the additional work offsets programmed with
$P_WPFRAME.
Displays the additional work offsets programmed with
$P_TRAFRAME.
Displays the additional work offsets programmed with
$P_PFRAME.
Displays the additional work offsets programmed with
$P_CYCFRAME.
Displays the active work offset, resulting from the total of
all work offsets.
Displays the active tool.
Displays the actual value in the Workpiece Coordinate
System.
Setting up the machine
3.5 Zero offsets
75