Siemens SINUMERIK 840D sl Operating Manual page 40

Introduction
2.4 Operator interface
Feed data
Display
F
Rapid traverse
0.000
Override
Spindle data
Display
S
S1
Speed
Symbol
Override
Spindle utilization
rate
Note
Display of logical spindles
If the spindle converter is active, logical spindles are displayed in the workpiece coordinate
system. When switching over to the machine coordinate system, the physical spindles are
displayed.
40
Meaning
Feed disable
Actual feed value
If several axes traverse, is displayed for:
"JOG" mode: Axis feed for the traversing axis
•
"MDA" and "AUTO" mode: Programmed axis feed
•
G0 is active
No feed is active
Display as a percentage
Meaning
Spindle selection, identification with spindle number and main spindle
Actual value (when spindle turns, display increases)
Setpoint (always displayed, also during positioning)
Spindle status
Spindle not enabled
Spindle is turning clockwise
Spindle is turning counterclockwise
Spindle is stationary
Display as a percentage
Display between 0 and 100%
The upper limit value can be greater than 100%.
See machine manufacturer's specifications.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Operating Manual, 01/2015, 6FC5398-6AP40-5BA2
Universal