Standard Views - Mitsubishi Electric WS0-CPU0 Operating Manual

Chapter 5
Figure 2:
The view can be selected
below the menu bar
Note
27
The graphical user interface
5.3

Standard views

The Setting and Monitoring Tool has the following views that can be accessed via
buttons below the menu bar.
 The structure of a MELSEC-WS safety controller consisting of various hardware
modules as well as the configuration of the inputs and outputs and the connected
elements are specified in the Hardware configuration view.
 The function logic can be configured by means of logic function blocks and
application-specific function blocks in the Logic editor view. This view is not
available unless a CPU module has been selected beforehand in the hardware
configuration.
 If the project contains at least one network module or if RS-232 communication is
enabled, the Network module [13] view is available. Here you can configure the
network module and the data that are transferred to and from the network.
Do not save the project data while Setting and Monitoring Tool is connected to the
MELSEC-WS safety controller.
Before saving the project data, disconnect the PC from the MELSEC-WS safety
controller.
 Complete information on the currently loaded project and all settings including the
logic programming and wiring diagrams is available in the Report view.
Furthermore, additional information on the project can be entered here. All
information can be saved in standard file formats and printed out. The scope of the
report can be compiled individually depending on the selection.
 The stored error messages are displayed as a history of a connected MELSEC-WS
safety controller in the Diagnostics view.
 Input and output signals from a MELSEC-WS safety controller can be recorded and
displayed inthe Data recorder view.