Mitsubishi Electric WS0-CPU0 Operating Manual page 94

Chapter 7
Figure 64:
Flexi Link system overview,
system connected, differing
configurations
Figure 65:
Flexi Link system overview,
system connected,
configuration identical but
not verified
Note
91
Flexi Link
The Setting and Monitoring Tool will connect to the Flexi Link system, compare the
existing hardware and software configuration with the configuration in the Designer
and display the results. If the configuration in the Setting and Monitoring Tool is not
identical to the configuration in the connected stations, these will be displayed with a
blue background.
Transfer the configuration
 Now transfer the configuration to the stations by clicking on Transfer. Again you will
be prompted to select which station(s) you want to transfer the configuration to.
 Select all stations and click on OK. The Setting and Monitoring Tool will now
transfer the configuration to each station. You will need the password for
Administrator; the default password is "MELSECWS".
 Once a valid configuration has been transferred to a station successfully, the
Setting and Monitoring Tool will ask you whether you want to set this station into the
Run state. Click either Yes or No. The station will be displayed in the Flexi Link
system overview with a grey background.
You can run or stop each station also in the Hardware configuration view for the
respective station.