Mitsubishi Electric WS0-CPU0 Operating Manual page 104

Chapter 7
Figure 77:
Flexi Link station A view
Note
101
Flexi Link
The toolbar
The toolbar contains icons for the following actions (from left to right):
 Reset to default: Sets the tag names and configured default settings for all bits and
bytes to the default values.
 Clear selected byte: Deletes all tag names for the selected byte and its bits and sets
the default value for all bits of this byte to Low.
 Undo the last action
 Redo the last action
How to edit the tag names:
 Click on a byte in the EFI1 or EFI2 area to display its bits in the lower half of the
window.
 Change the displayed tag names as desired. The bits will appear in the logic editor
in the Outputs tab with their new tag names.
 Some bits are reserved and can not be used or edited. These bits are displayed
grey in the upper half of the window.
 You can also delete tag names. Bits that have no tag name can not be used. They
will be displayed grey in the upper half of the window and they are not displayed in
the Flexi Link process image (see also Section 7.4.2).
How to set the default values:
 Click on a byte in the EFI1 or EFI2 area to display its content in the lower half of the
window.
 Now click once on the icon to the right of the tag name field of any bit to toggle this
bit's default value between 0 (Low) and 1 (High).
The set default value will be used in the Flexi Link system's process image if the
corresponding station has been suspended (see Section 7.4.6).