Flexi Link System: Process Image - Mitsubishi Electric WS0-CPU0 Operating Manual

Figure 71:
Flexi Link process image
Note
Flexi Link
7.4.2

Flexi Link system: Process image

The Flexi Link process image allows you to monitor the information that is
exchanged between the Flexi Link stations. In the left area of the screen the hardware
configuration for each station is displayed, on the right side the bits for EFI1 and EFI2
(if used) are displayed with their tag names. Bits that are currently High in the process
image are highlighted green.
 If a station is not in the Run state, its process image will be set to Low and its I/O
error status bits will be set to High (see Section 5.6.5).
 Double clicking on the hardware symbol for a station will open the routing view for
this station where you can edit the tag names for the bits and bytes sent from this
station (see Section 7.4.4).
Chapter 7
96