Front Panel - Extron electronics XTP II CrossPoint 6400 Setup Manual

Remote port connector
5
Figure 9.

Front Panel

CONFIG
A A
Figure 10.
Configuration port — If desired, connect a control system or
A
computer to the front panel Configuration port, a mini USB B port
Primary and Redundant Power Supply LEDs —
B
NOTES:
Green — Indicates that the associated power supply is operating
within normal tolerances.
Red — Indicates that the associated power supply is operating
outside the normal tolerances or has failed.
Pin RS-232 Function
1
2
1
3
4
5 Gnd
6
9 6
7
8
9
Remote RS-232/RS-422 Output Connector Wiring
CONTROL
ESC
ENTER PRESET VIEW VIDEO
PRIMARY 1 2
REDUNDANT 1 2
POWER
XTP II CROSSPOINT 1600
XTP SERIES DIGITAL MATRIX SWITCHER
B B
Front Panel Features
•
The XTP II CrossPoint 6400 and XTP II CrossPoint 3200 have
four power supplies installed and indicated.
•
The XTP II CrossPoint 1600 has two power supplies installed
and indicated in its standard configuration (only two LEDs
lit). It is available in a four-power-supply, redundant power
upgrade configuration, in which it indicates all four supplies.
XTP II CrossPoint 1600, 3200, and 6400 • Installation
RS-422
— Not used —
Tx Transmit Tx–
Rx Receive Rx–
— Not used —
Ground Gnd
— Not used —
— Not used Rx+
— Not used Tx+
— Not used —
I/O
AUDIO
Function
Not used
Transmit (–)
Receive (–)
Not used
Ground
Not used
Receive (+)
Transmit (+)
Not used
.
17