Extron electronics XTP II CrossPoint 6400 Setup Manual page 24

4. Loosely place the included tie wrap around the HDMI connector and
the LockIt lacing bracket (see
5. While holding the connector securely against the lacing bracket, use
pliers or similar tool to tighten the tie wrap (
excess length.
Local audio connectors
Do not tin the wires!
Figure 7.
ATTENTION:
•
•
NOTE:
connector
Analog video connectors
The universal analog video boards can accept RGB video and (with
adapters) component video, S-video, and composite video (see figure 8).
10 5
15
Figure 8.
For component video, use the R (R-Y) and R return pins (pins 1 and 6),
G (Y) and G return pins (pins 2 and 7), and B (B-Y) and B return pins
(pins 3 and 8).
For S-video, use the B, B return (C-chroma), G, and G return (Y-luma)
pins.
For composite video, use the G pin and the associated return pin.
Input only sync signals, no video signals, on the sync pins, 13 and 14.
16 XTP II CrossPoint 1600, 3200, and 6400 • Installation
Tip
Sleeve
Tip
Sleeve
Unbalanced Stereo Input
No Ground Here
Tip
Sleeves
Tip
No Ground Here
Unbalanced Stereo Output
Audio Input and Output Connector Wiring
For unbalanced audio output, connect the sleeves to the
ground contact. DO NOT connect the sleeves to the negative (-)
contacts.
Pour l'audio asymétrique, connectez les manchons au contact au
sol. Ne PAS connecter les manchons aux contacts négatifs (–).
The length of exposed wires is important (see the RS-232
NOTES
on page 15 for more information).
Pin Function
1 6
1 Red video
2 Green video
3 Blue video
11
4 Monitor ID bit
5 H. sync return
Analog Video Connector Wiring
on the previous page).
4
), then remove any
5
Tip
Ring
Sleeves
Tip
Ring
Balanced Stereo Input
Tip
Ring
Sleeves
Tip
Ring
Balanced Stereo Output
Pin Function
6 Red return
7 Green return
8 Blue return
9 Not used
10 V. sync return
Pin Function
11 Monitor ID bit
12 Monitor ID bit
13 H. sync
14 V. sync
15 Monitor ID bit