Extron electronics XTP II CrossPoint 6400 Setup Manual page 15

NOTE:
figure 4
2
3
4
XTP CP 4i Fiber 4K (fiber optic input board)
INPUTS
XTP IN
SIG LINK
LAN LAN
3 3 5 5 3 3
5
3
4
figure 2
See item on
A
on page 6.
XTP power indicators — Indicate the status of the power over
XTP (PoX) provided to the endpoint as follows:
Lit green — The board is providing XTP power to the endpoint.
Lit amber — XTP power is available, but disabled.
Blinking amber — XTP power is not available, but enabled.
Lit red — A wiring fault exists.
Unlit — The endpoint cannot receive power over XTP.
LAN connectors — As desired, connect a TP cable
between a host device or control LAN and this
connector for passive extension to the LAN (Ethernet)
connector on the connected endpoint (see
connectors on page 13 to wire the connector).
RS-232/IR Over XTP connectors — If desired,
connect serial RS-232 signals, modulated IR signals,
or both to these 3.5 mm, 5-pole captive screw
connectors for bidirectional RS-232 and IR communications on
the associated inputs (see
page 15 to wire the connectors).
XTP IN XTP IN
SIG LINK SIG
LAN
5 5 3 3 5 5
XTP In connectors — Connect up to four fiber
optic cable between these ports and the Tx port of
a compatible Extron fiber optic transmitter. This
board uses small form factor pluggable (SFP)
modules with industry-standard LC fiber optics connectors to
provide reliable physical connectivity and precise fiber core
alignment.
LAN connectors — As desired, connect a TP cable
between a host device or control LAN and this
connector for passive extension to the LAN (Ethernet)
connector on the connected endpoint (see
connectors on page 13 to wire the connector).
RS-232/IR Over Fiber connectors — If desired,
connect serial RS-232 signals, modulated IR signals,
or both to these 3.5 mm, 5-pole captive screw
connectors for bidirectional RS-232 and IR communications on
the associated inputs (see
page 15 to wire the connectors).
XTP II CrossPoint 1600, 3200, and 6400 • Installation
figure 3
on page 4,
RS-232 and IR connectors
XTP IN
RS-232 IR
LINK SIG LINK
Tx Rx G Tx Rx
LAN
3 3 5 5
RS-232 and IR connectors
on page 5, and
LAN
TP
RS-232 IR
Tx Rx Tx Rx
on
XTP CP 4i FIBER 4K
OVER FIBER
RS-232 IR RS-232 IR RS-232 IR
Tx Rx G Tx Rx Tx Rx G Tx Rx Tx Rx G Tx Rx
4 4
XTP IN
SIG LINK
LAN
TP
RS-232 IR
Tx Rx Tx Rx
on
7