Operation
This section describes the front panel operation of the FOX3 matrix switcher, including:
•
•
•
•
Front Panel Features
NOTE: Below is the front panel for the FOX3 Matrix 80x. The other Matrix frames have
Figure 9.
A
B
Front Panel Features
Power
Matrix Operations
Secure Direct Port Access
the same connection and power indicator LEDs.
Extron
Front Panel, FOX3 Matrix 80x Switcher
USB Config port — If desired, connect a control system or computer to the front panel
Configuration port.
NOTE: A front panel Configuration port connection and a rear panel Remote port
connection can both be active at the same time.
Primary and Redundant Power Supply LEDs — Light to indicate the power supply
status.
Green — Indicates that the associated power supply is operating within normal
•
tolerances.
•
Red — Indicates that the associated power supply is operating outside the normal
tolerances, there is no AC connected to the power supply, or the power supply
has failed (see
Removing and Installing a Module
power supply).
Unlit — Indicates that the power supply is not installed in the frame or is not fully
•
seated in the bay.
Source Information OSD
•
•
Reset Operations
Troubleshooting
•
POWER
CONFIG
PRIMARY
REDUNDANT
FOX3 MATRIX 80x
FIBER OPTIC DIGITAL MATRIX SWITCHER
A A
A
B
B B
on page 69 to replace the
FOX3 Matrix Series Switchers • Operation
16