Viewing And Adjusting The Audio Level - Extron electronics XTP II CrossPoint 6400 Setup Manual

Viewing and Adjusting the Audio Level

NOTES:
•
•
1.
Press and hold the Audio button until it flashes.
AUDIO
Press and
hold.
2.
Press an input or output button. The output buttons display the
input level and the input buttons display the volume; the more lit
buttons, the higher the level (see the "Operation" section of the
XTP II CrossPoint 1600, 3200, and 6400 Series User Guide to read
the displayed value).
3.
Increase/decrease the level or volume by pressing the Esc (
View (
the level or volume.
4. Press and release the Audio button to exit.
Viewing Ties (and Muting Outputs)
1.
Press the View button. Output buttons light for outputs that have no
ties established.
NOTE:
2. Press an input button. The buttons for all tied outputs light.
3.
Press an output button. The buttons for the tied input and all tied
outputs light.
4. Press the View button again to exit View mode. All input and output
buttons return to an unlit state.
Gain and attenuation can be adjusted for local inputs only.
Volume can be adjusted for the local outputs only.
2 seconds
Audio button blinks.
Press an Input button to adjust gain/attenuation.
5
Press an Output button to adjust volume.
1 2
Output buttons display gain/attenuation.
Input buttons display volume.
17 18
1
) buttons.
<
button decreases
the level or volume.
VIEW ESC
If an output button blinks, that output is muted. To
toggle mute on and off, press and hold the output button for
2 seconds.
XTP II CrossPoint 1600, 3200, and 6400 • Front Panel Operations
AUDIO
Lit button Unlit button
1
button increases
) and
>
21