Number Of Connections - Extron electronics XTP II CrossPoint 6400 Setup Manual

Number of Connections

A switcher can have up to 200 simultaneous TCP connections, including
all HTTP sockets and Telnet connections. When the connection limit is
reached, the switcher accepts no new connections until some have been
closed. No error message or indication is given that the connection limit
has been reached. To maximize the performance of your switcher, keep
the number of connections low and close unnecessary open sockets.
Establishing a USB Port Connection
A standard USB cable and the Extron DataViewer utility, version 2.0
or newer, can be used for connection to the XTP II CrossPoint matrix
switcher Configuration port. The USB cable, available at any local
electronics store, should be terminated on one end with a USB mini-B
male connector.
NOTE:
Before you use the USB port for the first time, install the
USB driver on your computer. The simplest way to do this is to
install the XTP System Configuration software and then run the
Found New Hardware Wizard.
Host-to-Switcher Instructions
The switcher accepts SIS commands through its serial port, its USB port,
or its LAN port. SIS commands consist of one or more characters per
command field. They do not require any special characters to begin or
end the command character sequence. Each switcher response to an
SIS command ends with a carriage return and a line feed (CR/LF =
which signals the end of the response character string. A string is one or
more characters.
NOTE: The tables that begin on the next page are a partial list of SIS
commands. For a complete listing, see the XTP II CrossPoint 1600,
3200, and 6400 Series User Guide.
Common SIS Command Symbols
The following symbols are used throughout the command and response
tables, which start on
• = Space
= Carriage return and line feed
]
}
= Carriage return (no line feed)
|
= Pipe (can be used interchangeably with the
E
= Escape key (hex 1B)
W = Can be used interchangeably with the
page 25:
XTP II CrossPoint 1600, 3200, and 6400 • Remote Control
}
character)
E
character
),
]
23