Arrangement Of Command And Response Tables - Extron electronics XTP II CrossPoint 6400 Setup Manual

Arrangement of Command and Response Tables

The following pages present five command and response tables, each
defining a subset of SIS commands and their responses, with examples
where appropriate. The following tables are presented:
•
SIS Command and Response Table for Matrix Switcher
Commands, starting on the next page — SIS commands to control
and monitor the XTP II CrossPoint switcher itself and specific input
and output boards
•
SIS Command and Response Table for Transmitter
starting on page 36 — SIS commands to control and monitor the
XTP T HDMI and XTP T HWP 101 transmitter endpoints from the
matrix switcher
•
SIS Command and Response Table for Receiver
starting on page 38 — SIS commands to control and monitor the
XTP R HDMI, XTP SR HDMI, and XTP R HWP 101 receiver endpoints
from the matrix switcher
• SIS Command and Response Table for Switching Transmitter
Endpoint, starting on page 41 — SIS commands to control and
monitor the XTP T USW 103 switcher endpoint from the matrix
switcher
• SIS Command and Response Table for IP-Specific
starting on page 44 — SIS commands to control and monitor the IP
interface of the XTP II CrossPoint matrix switcher
24 XTP II CrossPoint 1600, 3200, and 6400 • Remote Control
Endpoints,
Endpoints,
Commands,