Extron electronics XTP II CrossPoint 6400 Setup Manual page 40

Command
Captive screw and Ethernet serial port insertion enables (available for inputs and outputs on XTP CP 4i , XTP CP 4o [XTP input and
output], and XTP CP 4i fiber, and XTP CP 4o fiber boards only)
Enable an input captive screw
serial port insertion
Enable an input Ethernet serial port
insertion
Set all RS-232 input insertions
View input insertion
View all input insertions
Enable an output captive screw
serial port insertion
Enable an output Ethernet serial
port insertion
Set all RS-232 output insertions
View output insertion
View all output insertions
NOTE: X! = Input number
X@
= Output number
X1^
= Captive screw or UART
SIS Command Response
(Host to Unit) (Unit to Host)
E X! } X!
I *0LRPT LrptI
E X! } X!
I *1LRPT LrptI
E X1^ }
I *LRPT LrptI00*
E X! } X1^]
I LRPT
E } X1^ X1^
ILRPT
1 2
E X@ } X@
O *0LRPT LrptO
E X@ } X@
O *1LRPT LrptO
E X1^ }
O *LRPT LrptO00*
E X@ } X1^]
O LRPT
E } X1^ X1^
OLRPT 1 2
01 – 16 , 32, or 64
01 – 16 , 32, or 64
0 = Captive screw RS-232 insert (default)
Additional Description
]
*0
Enable the captive screw serial port insert on input
disables the Ethernet RS-232 insert.
]
*1
Enable the Ethernet serial port insert on input
disables the captive screw serial port insert.
X1^]
X1^ X1^ ] X1^
...
3 n One for each installed input, starting at input 1. Inputs
that are not on an input board report as 0.
]
*0
Enable the captive screw serial port insert on output
This disables the Ethernet serial port insert.
]
*1
Enable the Ethernet serial port insert on output
disables the captive screw serial port insert.
X1^]
X1^ X1^ ] X1^
3 ... n
One for each installed output, starting at output 1.
Outputs that are not on an output board report as 0.
1 = Ethernet RS-232 insert (UART)
X!
. This
X!
. This
X@
.
X@
. This