Extron electronics XTP II CrossPoint 6400 Setup Manual page 17

NOTE:
figure 4
7
XTP CP 4i VGA (universal analog video input board)
IN
£ £
£
7
NOTE:
figure 4
Output boards space
B
boards.
XTP CP 4o (XTP output board)
OUT
SIG LINK SIG
PWR PWR
XTP LAN XTP
2 2 1 1 3 3 2 2 1 1
1
figure 2
See item on
A
on page 6.
Audio (local audio) connectors — Connect balanced
or unbalanced stereo audio inputs to these 3.5 mm,
5-pole captive screw connectors (see
connectors on page 16 to wire the connectors).
£ £ £ £
VGA connectors — Connect up to four VGA
cables between these ports and the analog
video output port of the video sources.
NOTE: This universal analog video board can accept RGB
video and (with adapters) component video, S-video, and
composite video (see
to wire the connectors for various analog video formats).
Audio (local audio) connectors — Connect balanced
or unbalanced stereo audio inputs to these 3.5 mm,
5-pole captive screw connectors (see
connectors on page 16 to wire the connectors).
figure 2
See item on
B
on page 6.
—
LINK SIG LINK
PWR
LAN XTP LAN
3 3 2 2 1 1 3 3
XTP output connectors — Connect a TP cable
between this connector and a compatible Extron
XTP receiver (see TP connectors
wire the connector).
ATTENTION:
• Do not connect these ports to a computer data or
telecommunications network.
• Ne connectez pas ces ports à des données
informatiques ou à un réseau de télécommunications.
XTP II CrossPoint 1600, 3200, and 6400 • Installation
figure 3
on page 4,
Local audio
L
£ £
Analog video connectors
Local audio
figure 3
on page 4,
Make connections to installed output
SIG LINK
RS-232
PWR
XTP LAN
Tx Rx Tx Rx
2 2 1 1 3 3
on page 13 to
on page 5, and
L
XTP CP 4i VGA
AUDIO
R L R L R L R
7 7
on page 16
L
on page 5, and
IR/RS-232 OVER XTP
IR RS-232 IR RS-232 IR RS-232 IR
Tx Rx Tx Rx Tx Rx Tx Rx Tx Rx Tx Rx
4 4
SIG
PWR
XTP
R
R
XTP CP 4o
LINK
9