Configuration - Extron electronics XTP II CrossPoint 6400 Setup Manual

Configuration

Removing and Installing a Board or Blank Panel
NOTES:
•
•
Circuit boards can be added or removed to increase or decrease the I/O
configuration (size) of the switcher. Remove and replace an I/O board or
blank panel as follows:
1. For a board, disconnect any connected cables.
2. Rotate the left and right knurled knobs to completely loosen the
captive screws.
3.
Gently pull on the knurled knobs to loosen the board or panel from
the backplane.
4. Slide the board or panel out of the chassis (see
page).
ATTENTION:
5. Place the removed board on an anti-static surface or in an anti-static
container.
6. For a board, orient the board to be installed horizontally
(XTP II CrossPoint 1600) or vertically (XTP II CrossPoint 3200 and
XTP II CrossPoint 6400) and so that the IN or OUT silkscreen on the
back panel is right side up.
7. For a board, align the board with the left and right chassis guides
(see
8.
Gently slide the board or blank panel into the enclosure. For a board,
slide it toward the front panel until it meets resistance.
For proper cooling and air flow, boards or blank panels should
be installed in all locations during normal switcher operations.
The input and output boards are hot-swappable. You do not
need to power down the switcher to remove and install a board.
•
Do not touch the electronic components or the connectors
on the backplane or on the circuit boards without being
electrically grounded. Handle circuit boards by their edges
only. Electrostatic discharge can damage circuits, even if
you cannot feel, see, or hear it.
• Ne pas toucher les composants électroniques ou les
connecteurs sur la carte mère ou sur les circuits imprimés
sans être électriquement relié à la terre. Manipuler les
circuits imprimés en les tenant seulement par leurs bords.
Les ESD peuvent endommager l'équipement, même si vous
ne pouvez pas le sentir, le voir ou l'entendre.
figure 13).
XTP II CrossPoint 1600, 3200, and 6400 • Configuration
figure 13 on the next
47