Toggling Between Mode 2 And Mode 0 - Extron electronics XTP II CrossPoint 6400 Setup Manual

Selecting Lock Mode 2 or Toggling Between
Mode 2 and Mode 0
NOTES:
•
•
Toggle the lock on or off by pressing and holding the Preset , View ,
and Esc buttons simultaneously until the buttons flash (approximately
2 seconds).
Lock mode 2
C O N T R O L
ENTER PRESET VIEW ESC
Press and hold for
2 seconds.
Selecting Lock Mode 2 or Toggling Between
Mode 2 and Mode 1
NOTES:
•
•
Toggle the lock on and off by pressing and holding the View button and
the Esc button simultaneously for approximately 2 seconds.
Lock mode 1
C O N T R O L
ENTER
PRESET VIEW ESC
Press and hold for
2 seconds.
20 XTP II CrossPoint 1600, 3200, and 6400 • Front Panel Operations
If the switcher is in Lock mode 0 or mode 1, this procedure
selects mode 2. The Preset , View , and Esc buttons flash
twice.
If the switcher is in Lock mode 2, this procedure selects mode 0
(unlocks the switcher). The View and Esc buttons flash twice.
C O N T R O L
ENTER
PRESET VIEW ESC
If the switcher is in Lock mode 0 or mode 1, this procedure
selects mode 2. The Preset , View , and Esc buttons flash
twice.
If the switcher is in Lock mode 2, this procedure selects mode 1.
The View and Esc buttons flash twice.
C O N T R O L
ENTER PRESET VIEW ESC
Lock mode 0
C O N T R O L
ENTER PRESET VIEW ESC
Press and hold for
2 seconds.
Lock mode 2
C O N T R O L
ENTER
PRESET VIEW ESC
Press and hold for
2 seconds.
C O N T R O L
ENTER PRESET
VIEW ESC
C O N T R O L
ENTER PRESET VIEW ESC