Endpoint Configuration - Extron electronics XTP II CrossPoint 6400 Setup Manual

The XTP II CrossPoint models are assembled from user-installed and
hot-swappable input and output boards.
identifies the types of input boards and output boards currently available,
each of which can receive (input boards) or output (output boards) up to
four signals (see
The XTP II CrossPoint 1600 can support up to four input boards and four
output boards of any of the type listed in table 1, for a total of 16 inputs
and 16 outputs.
The XTP II CrossPoint 3200 can support up to eight input boards and
eight output boards of any of the type listed in table 1, for a total of
32 inputs and 32 outputs.
The XTP II CrossPoint 6400 can support up to 16 input boards and
16 output boards of any of the type listed in table 1, for a total of
64 inputs and 64 outputs.
The matrix switcher can be remotely controlled via an Ethernet LAN port,
serial port, or USB port connection using either the Extron XTP System
Configuration Software or the Simple Instruction Set (SIS).

Endpoint Configuration

In an XTP system, the transmitters connected to the input boards and
the receivers connected to the output boards are known as "endpoints".
When you configure an XTP system (consisting of an XTP II CrossPoint
matrix switcher and its connected endpoints), connect a computer to the
matrix switcher and configure the endpoints from the matrix switcher.
Do not connect the computer directly to the endpoint for configuration
when it is part of an XTP system.
Swapping Boards and Endpoints
When you replace an input board, an output board, or an endpoint, the
matrix switcher automatically applies the settings to the new device. If
the stored settings are incompatible with the newly installed device, the
matrix switcher applies a default configuration.
Inputs and Outputs
XTP II CrossPoint 1600, 3200, and 6400 • Introduction
Table 1
on the previous page
on page 5 for details).
3