Introduction - Extron electronics XTP II CrossPoint 6400 Setup Manual

Introduction

This section gives an overview of the Extron XTP II CrossPoint 1600,
XTP II CrossPoint 3200, and XTP II CrossPoint 6400 Series configurable
matrix switchers and describes their features. Topics that are covered
include:
•
About this Guide
•
About the XTP II CrossPoint Matrix Switchers
About this Guide
NOTE:
the XTP II CrossPoint 1600, 3200, and 6400 Series User Guide,
available at
This setup guide helps you to easily and quickly set up and configure
your XTP II CrossPoint 1600, 3200, and 6400 switcher. Step by step
instructions show you how to:
•
Install the input and output boards (see
Board or Blank Panel
• Connect the hardware (see
•
Perform basic operations (see
• Use both the front panel controls (see
on page 18) and selected Simple Instruction Set (SIS) commands
(see
• Connect to the built-in HTML pages, which you can use to operate
the switcher (see
•
Reconfigure the switcher by adding or removing boards (see
Removing and Installing a Board or Blank Panel
About the XTP II CrossPoint Matrix Switchers
The XTP II CrossPoint matrix switchers (see
distribute and transcode signals in a variety of video and audio formats,
identified by the input and output boards installed, defined in
on the next page. The matrix switcher routes an input signal of a format
supported by an installed input board to any combination of outputs with
formats supported by installed output boards. The matrix switcher can
route multiple input-to-output configurations simultaneously.
For more information on any subject in this guide, see
www.extron.com
on page 47)
Selected SIS Commands
Accessing the HTML Pages
XTP II CrossPoint 1600, 3200, and 6400 • Introduction
.
Removing and Installing a
Inputs and Outputs
Front Panel Operations
Front Panel Operations
on page 22)
on page 45
figure 1, on the next page)
on page 5)
on page 18)
on page 47)
table 1
1