Sis Command And Response Table For Receiver Endpoints - Extron electronics XTP II CrossPoint 6400 Setup Manual

SIS Command and Response Table for Receiver Endpoints

NOTE: These commands allow you to control and monitor the HDMI receiver endpoint from the matrix switcher.
Command
HDCP status
View output HDCP status
View HDCP status of all outputs
Video mutes
Video mute
Video unmute
Read video mute
Global video mute
Global video unmute
Audio output volume
Set the volume to a specific
value
Example:
Increment volume
Example:
Decrement volume
Read output volume
NOTE: • = Space
X@
= Output number
X1)
= Mute
X1%
= Volume adjustment range
X(
= HDCP status (for outputs)
SIS Command Response
(Host to Unit to Endpoint) (Endpoint to Unit to Host)
E X@ } X(]
O HDCP
E } X(
O*HDCP
X@
*1B Vmt
X@
*0B Vmt
X@ X1)]
B
1*B Vmt1
0*B Vmt0
X@ X1%
* V Out
1*50v Out01•Vol50
X@
+V Out
1+V Out01•Vol51
X@
–V Out
X@ X1%]
V
01 – 16, 32, or 64
0 = off (unmuted)
0 – 64 (1 dB/step except for 0-to-1, which is 22 dB) (default = 64 [0 dB])
0, 2, 4, or 6 = No monitor connected
1, 3, or 5 = Monitor connected but not encrypted
7 = Monitor connected and encrypted
Additional Description
X( X( X( ]
...
1 2 3 n
X@ ]
*1
Mute output
X@ ]
*0
Unmute output
1 = mute on, 0 = mute off.
]
Mute all video outputs.
]
Unmute all video outputs.
X@ X1%]
•Vol
]
Set output 1 volume to 79%.
X@ X1%]
•Vol Increase volume by 1 step.
]
X@ X1%]
•Vol Decrease volume by 1 step.
1 = on (muted)
X@
(video off).
X@
(video on).