Front Panel Operations - Extron electronics XTP II CrossPoint 6400 Setup Manual

Front Panel Operations

This section describes simple XTP II CrossPoint matrix switcher
operation from the front panel. Topics that are covered include:
•
Creating a Tie
•
Saving or Recalling a Preset
•
Setting the Front Panel Locks (Executive Modes)
• Viewing and Adjusting the Audio Level
•
Viewing Ties (and Muting Outputs)
Creating a Tie
A "tie" is an input-to-output connection.
A "set of ties" is an input tied to two or more outputs. (An output can
never be tied to more than one input.)
A "configuration" is one or more ties, one or more sets of ties, or a
combination.
1. Press and release the Esc button to clear any input button, output
button, or control button indicators that may be lit.
2. Press and release the Video and Audio I/O buttons to select or
deselect video, audio, or both as desired.
Green when selected
Off when deselected
NOTE:
3.
Press and release the desired input button.
The button lights to indicate the selection.
4. Press and release the desired output buttons.
Amber indicates video and audio tie.
Green indicates video only tie.
Red indicates audio only tie.
5.
Press and release the Enter button. All button indicators turn off.
18 XTP II CrossPoint 1600, 3200, and 6400 • Front Panel Operations
VIDEO
Audio or video can be broken away (tied by itself) by
selecting only the Video button or only the Audio button.
5
3 4 8
I / O
Red when selected
AUDIO
Off when deselected
Green indicates the need
ENTER
to confirm the change.