Extron electronics XTP II CrossPoint 6400 Setup Manual page 16

NOTE:
figure 4
XTP II CP 4i HD 4k PLUS and XTP CP 4i HDMI (HDMI input boards)
INPUTS
6 6
IN
6 6
6
7
XTP CP 4i DVI Pro (DVI Pro input board)
IN
8 8
8
7
XTP CP 4i 3G-SDI (3G/HD-SDI/SDI video input board)
IN
INPUT LOOP OUT
9 9 ¢ ¢
9
¢
8 XTP II CrossPoint 1600, 3200, and 6400 • Installation
figure 2
See item on
A
on page 6.
6 6 6 6
6 6 6 6
HDMI connectors — Connect up to four HDMI
cables between these ports and the HDMI output port
of the digital video sources.
NOTE: See HDMI connectors
connector with a LockIt HDMI Cable Lacing Bracket.
Audio (local audio) connectors — Connect
balanced or unbalanced stereo audio inputs to these
3.5 mm, 5-pole captive screw connectors (see
audio connectors on page 16 to wire the connectors).
8 8 8 8
DVI connectors — Connect a DVI cable
between this port and the DVI output port of
the digital video source.
Audio (local audio) connectors — Connect balanced
or unbalanced stereo audio inputs to these 3.5 mm,
5-pole captive screw connectors (see
connectors on page 16 to wire the connectors).
INPUT LOOP OUT INPUT LOOP OUT
9 9 ¢ ¢ 9 9 ¢ ¢
Input connectors — Connect a 3G-SDI,
HD-SDI, or SDI video input to this BNC
connector.
Loop Out connector — Connect a local digital display to this
BNC connector for buffered loop-through of the input signal.
3G/HD-SDI/SDI
NOTE: The
terminators on the Loop Out connectors. Extron recommends
leaving these installed when the loop out is not used.
figure 3
on page 4,
L R
6 6
L R
6 6
on page 15 to secure the
L R
8 8
Local audio
INPUT LOOP OUT
L R
9 9 ¢ ¢
board ships with 75-ohm
on page 5, and
XTP II CP 4i HD 4K PLUS
AUDIO
L R L R L R
7 7
XTP CP 4i HDMI
AUDIO
L R L R L R
7 7
L R
Local
XTP CP 4i DVI Pro
AUDIO
L R L R L R
7 7
L R
XTP CP 4i 3G-SDI
AUDIO
L R L R L R
7 7
INPUT LOOP OUT