Output A,B: Shutter - Drive Parameter Window - ABB i-bus KNX JRA/S 6.230.3.1 Product Manual

Blind/roller shutter actuator with binary inputs
Table of Contents

Advertisement

®
ABB i-bus
KNX
Commissioning
3.3.2.3.1

Output A,B: Shutter - Drive parameter window

Settings for the shutter drive are undertaken in this parameter window. It is visible if the Operation mode
parameter is set to Shutter in the Output A,B Operation mode parameter window, p. 22.
Total travel time
in s [1...18,000]
Options:
This parameter defines the total travel time from the upper end position to the lower end position.
Reversing time delay in ms [50...5,000]
(see techn. data of the drive!)
Options:
This parameter defines the duration of the minimum reversing time between two directions of travel.
Outputs are disconnected from voltage
after
Options:
End position...: The application calculates the travel time required from the current position to the end
position. On reaching the end position (the very top or bottom), the shutter drive will switch off
independently. A so-called "overrun" can be set to ensure that the Blind/Roller Shutter Actuator safely
reaches the end position. Thus, the voltage remains applied for a short time so as to move the drive
definitively to the end position.
Total travel time + 10% overrun: The shutter drive is always activated for the set total travel time +
10% regardless of the current position of the shutter.
For further information see: Travel times, p. 115
62 2CDC506083D0201 | JRA/S 6.230.3.1
1...60...18,000
50...700...5,000
End position, no overrun
End position + 2% overrun
End position + 5% overrun
End position + 10% overrun
End position + 20% overrun
Total travel time + 10% overrun

Advertisement

Table of Contents
loading

Table of Contents