Output A,B: Blind - Automatic Parameter Window - ABB i-bus KNX JRA/S 6.230.3.1 Product Manual

Blind/roller shutter actuator with binary inputs

Table of Contents

ABB i-bus

KNX

Commissioning

3.3.2.1.2

Output A,B: Blind - Automatic parameter window

This parameter window is used to make settings for the Automatic function. It is visible if the

Enable function Automatic parameter is set to Yes in the Output A,B: Blind parameter window, p. 22.

The Automatic function enables simple automatic sun protection, and automatic protection against dazzle

in conjunction with the Shutter Control Unit.

For further information see: Automatic sun protection, p. 120 and Output A,B: Blind and Shutter group objects, p. 109

Deactivation by direct operation

Options:

This parameter defines how the Automatic function is deactivated: via either the Activation of autom.

control group object or via direct operation.

Note

The position of the blind or shutter is also stored in the event of bus voltage failure if the Automatic

function is activated. The blind or shutter remains in the same position.

On bus voltage recovery, the position is retained and the group object value is undefined. The value is

not updated until the next Move telegram.

If the Activation of autom. control group object has not been assigned a group address, the Automatic

function is deactivated when there is a download.

If Automatic is active, it remains on after a download until the next manual override or until it is

deactivated by the Activation of autom. control group object.

Yes

JRA/S 6.230.3.1 | 2CDC506083D0201 29

Table of Contents