Planning And Application; Output A,B; Drive Types; General Functions - ABB i-bus KNX JRA/S 6.230.3.1 Product Manual

®
ABB i-bus KNX

Planning and application

4 Planning and application
In this chapter you will find some tips and application examples for practical use of the device.
4.1

Output A,B

This chapter explains the drive types and application examples for Output A,B.
4.1.1

Drive types

Output A,B can control two drive types – blind or shutter:
1. Blind
The drive moves the blind UP/DOWN and OPENs/CLOSEs slat adjustment.
2. Shutter
The drive moves the shutter UP and DOWN. In contrast to the blind drive type, there are no group objects
available for slat control.
4.1.2

General functions

The general functions of the blind and shutter are the same. Therefore they are explained below based on
the blind settings.
4.1.2.1

Travel times

Total travel time
The total travel time is the time that a blind requires to move from fully upwards to fully downwards.
Should the Blind/Roller Shutter Actuator receive an UP or DOWN Move telegram, the corresponding
output is switched and the blind is moved in the appropriate direction.
The blind is moved in this direction until the Blind/Roller Shutter Actuator receives a STOP telegram or
the upper or lower end positions are reached and the motor is switched off by the limit switch.
JRA/S 6.230.3.1 | 2CDC506083D0201 115