Table of Contents
Advertisement
®
ABB i-bus
KNX
Planning and application
4.1.2.4
Move to position in % [0...100]
The blind can be moved to any position via an 8-bit value. In Blind operation mode, the slats can also be
positioned at any angle via an 8-bit value.
This means you can determine which position the blind should move to each and every time a new Move
telegram is received. For example, it is possible to set the position direct from a display or visualization
terminal using a value.
4.1.3
Automatic control
Using automatic control makes it possible to provide a convenient automatic sun protection system as well
as to feed back the status of the blind.
JRA/S 6.230.3.1 | 2CDC506083D0201 119
Advertisement
Table of Contents
