Table of Contents
Advertisement
®
ABB i-bus
KNX
Commissioning
3.4.5
Output A,B: Blind and Shutter group objects
This section explains the Output A,B: Blind and Shutter group objects using the Blind option. If the blind
option has a special function or if the function is not available, e.g. slat adjustment, this is clearly indicated.
Otherwise, the explanations apply for both operation modes.
No.
75
This group object is enabled if the Mode Output parameter is set to Blind in the Output A,B: Mode parameter window.
If this group object receives a telegram with the value 0, the blind moves UP. If it receives a telegram with the value 1, it
moves DOWN. The output contact returns to the neutral middle position after the Total travel time has elapsed.
Telegram value
76
This group object is enabled if the Mode Output parameter is set to Blind in the Output A,B: Mode parameter window.
This group object stops the shutter or blind during movement. When the shutter is stopped, the group object is used for slat
adjustment, one step UP (0) or DOWN (1).
If the blind is moving, the movement stops if a telegram is received on this group object, regardless of whether a 0 or a 1 is
received.
Blind mode: If the blind is at a standstill when this group object receives a telegram the blind is moved UP (0) or DOWN (1) for
the duration of slat adjustment and then stops.
Shutter mode: If the shutter is at a standstill when this group object receives a telegram, no action is undertaken.
Telegram value
77
This group object is enabled if the Mode Output parameter is set to Blind in the Output A,B: Mode parameter window.
This group object is used for movement to and feedback of a determined position (0 = top, 255 = bottom).
If this group object receives a telegram the blind is moved to the position corresponding to the received value.
After the target position is reached, the slats will assume the same position as before the movement started. If an Adjust slat
0...255 telegram is received during movement, the slats move to the received target position.
Telegram value:
Function
Move UP/DOWN
0 = UP
1 = DOWN
STOP/Slat adj. OPEN/CLOSE and/or
STOP UP/DOWN
0 = STOP/slat adjustment UP
1 = STOP/slat adjustment DOWN
Move to position
0
= upper
...
= Intermediate position
255 = lower
Object name
Data type
Blind Output A,B
1 bit
Shutter Output A,B
DPT 1.008
Blind Output A,B
1 bit
Shutter Output A,B
DPT 1.007
Blind Output A,B
1 byte
Shutter Output A,B
DPT 5.001
JRA/S 6.230.3.1 | 2CDC506083D0201 109
Flags
C, W
C, W
C, W, T
Advertisement
Table of Contents
