Table of Contents
Advertisement
®
ABB i-bus
KNX
Device technology
2.4
Mounting and installation
The device is a modular installation device for quick installation in distribution boards on 35 mm mounting
rails to DIN EN 60 715.
The installation position can be selected as required.
Electrical connection is via screw terminals. The device connects to the bus via the supplied bus
connection terminal. The terminal assignment is located on the housing.
The device is ready for operation after connection to the bus voltage.
The devices must be accessible for the purposes of operation, testing, visual inspection, maintenance and
repair in compliance with DIN VDE 0100-520.
Commissioning requirement
In order to commission the device, a PC with ETS, as well as a connection to the ABB i-bus
e.g. via a KNX interface, is required.
The device is ready for operation after the bus voltage is applied. No additional auxiliary voltage
is required.
Mounting and commissioning may only be carried out by electrical specialists. The applicable standards,
directives, regulations and specifications for the country in question must be observed when planning and
setting up electrical installations and security systems for intrusion and fire detection.
•
Protect the device from damp, dirt and damage during transport, storage and operation.
•
Only operate the device within the specified technical data!
•
The device should only be operated in an enclosed housing (distribution board)!
•
Switch off the device supply voltage before mounting.
To avoid dangerous touch voltages which originate through feedback from differing phase conductors,
all poles must be disconnected when extending or modifying the electrical connections.
Danger
®
,
JRA/S 6.230.3.1 | 2CDC506083D0201 13
Advertisement
Table of Contents
