Table of Contents
Advertisement
®
ABB i-bus
KNX
General
1.2
Overview of product and functions
The Blind/Roller Shutter Actuator controls blinds or shutters. The input signals are detected via binary
inputs or directly via the sensors connected to the KNX.
The Blind/Roller Shutter Actuator is a modular installation device with a module width of 12 units in Pro M
design for installation in the distribution board. It connects to the ABB i-bus® via a bus connection terminal
at the front. The device can be operated manually, for example during commissioning, by applying an
auxiliary voltage to the bus terminals. Physical address assignment and parametrization are carried out
with the ETS Engineering Tool Software.
The device has six changeover contacts for actuating blinds, shutters or window curtains. They can also
be programmed as switch outputs, e.g.:
•
As a blind output: blinds, curtains or shutters
•
As a switch output: switching for lights and consumers
It also has twelve floating binary inputs. These are used to control the blind/shutter channels. They can
also be used for the lighting switch function.
The scanning voltage for the binary inputs is provided by the device. The binary inputs are divided into six
groups of two.
Overview of the number and allocation of the inputs and outputs:
Inputs
Binary via contact scanning
Outputs
6 A changeover contact (blind) or
6 A switching contact
JRA/S 6.230.3.1
12
JRA/S 6.230.3.1
6
JRA/S 6.230.3.1 | 2CDC506083D0201 5
Advertisement
Table of Contents
