Table of Contents
Advertisement
®
ABB i-bus
KNX
Planning and application
4.2.2.3
Flashing
The output can flash, i.e. switch on and off periodically.
The switch on time (T
Note
The contact life of the contacts should be considered and can be found in the technical data. Limiting
the number of switching operations with the parameter Number of ON impulses may be useful.
Furthermore, a delay in the switching sequence may possibly be caused by the limited availability of
switching energy with very frequent switching. The possible number of switching operations should be
considered.
130 2CDC506083D0201 | JRA/S 6.230.3.1
) and switch off time (T
ON
OFF
) during flashing can be parametrized.
Advertisement
Table of Contents
