Output A,B: Switch Actuator - Time, Flashing Parameter Window - ABB i-bus KNX JRA/S 6.230.3.1 Product Manual

®
ABB i-bus KNX
Commissioning
3.3.2.2.2

Output A,B: Switch actuator - Time, Flashing parameter window

All settings for the Time function – Staircase lighting, Switching ON/OFF delay and flashing – are
undertaken in this parameter window. It is visible if the Enable function Time parameter is enabled in
Output A,B: Switch actuator (only "UP" contact) parameter window, p. 38.
Observe the contact life span and switching cycles per minute.
Note
For the contact life and switching operations per minute, see Technical data, p 7
Time function
Options:
This parameter defines the type of Time function for each output.
•
Staircase lighting: The staircase lighting is switched via an ON telegram from the output A Switch
group object, the value of which can be parametrized. The staircase lighting time starts when the
function is switched on. It is switched off immediately after the staircase lighting time ends.
Note
The Staircase lighting function can also be called via the Switch, Logical connection x (x = 1, 2) group
object or with a light scene recall.
•
Switching ON/OFF delay: The output can be switched on or off with a delay via this function.
Staircase lighting
Switching ON/OFF delay
Flashing
JRA/S 6.230.3.1 | 2CDC506083D0201 47