Output A,B: Shutter Parameter Window - ABB i-bus KNX JRA/S 6.230.3.1 Product Manual

®
ABB i-bus KNX
Commissioning
3.3.2.3

Output A,B: Shutter parameter window

All settings for A: Shutter are made in this parameter window. It is visible if the Operation mode parameter
is set to Shutter in the Output A,B Operation mode parameter window, p. 22.
Reaction on bus voltage failure
Options:
The output can assume a defined state on bus voltage failure via this parameter.
•
Unchanged: The relay position of the outputs does not change. Any movements in progress are
therefore performed to completion.
•
UP/DOWN/STOP: Sets a fixed relay contact position.
Note
If the relay has been switched immediately before a bus voltage failure, it may not be possible to
implement the options UP and DOWN.
The power stored in the Blind/Roller Shutter Actuator may not be sufficient for this.
58 2CDC506083D0201 | JRA/S 6.230.3.1
Unchanged
UP
DOWN
STOP