Distinction Between Long And Short Operation - Yes - ABB i-bus KNX JRA/S 6.230.3.1 Product Manual

®
ABB i-bus KNX
Commissioning
3.3.3.2.2 Distinction between long and short operation – Yes
If the parameter Distinction between long and short operation is set to Yes, the following parameters
appear:
Short operation => Event 0
Long operation => Event 1
Input on operation
Options:
•
Open: Operation opens the input.
•
Closed: Operation closes the input.
If a normally open contact is connected to the input, the option Closed should be selected; on a normally
closed contact the option Open should be selected.
Long operation after ...
Options:
Here the time period T
Note
The remaining parameter descriptions can be found in the Distinction between long and short operation
– No, p. 72.
74 2CDC506083D0201 | JRA/S 6.230.3.1
Open
Closed
0.3/0.4/0.5/0.6/0.8 s
1/1.2/1.5 s
2/3/4/5/6/7/8/9/10 s
, after which an operation is considered a "long" operation, is defined.
L