Table of Contents
Advertisement
®
ABB i-bus
KNX
Commissioning
3.3.3.4.1
Parameter Distinction between long and short operation – No
If the parameter Distinction between long and short operation is set to No, the following parameters appear
in the Input a: Value/forced operation parameter window, p. 85:
Activate minimum signal duration
Options:
•
Yes: The following parameters appear:
No
Yes
For rising edge
in value x 0.1 s [1...65,535]
Options:
1...10...65,535
Note
A rising edge corresponds to a "normally opened contact function".
For falling edge
in value x 0.1 s [1...65,535]
Options:
1...10...65,535
Note
A falling edge corresponds to a normally closed contact function.
JRA/S 6.230.3.1 | 2CDC506083D0201 87
Advertisement
Table of Contents
