Shim Clearance; Backlash - Suzuki Madura GV700GL Service Manual

4-33 SHAFT DRIVE
FINAL GEAR BEARING CASE SHIM
CLEARANCE
• Measure the clearance between the shims and
bearing. If it is not within the specification, the
shims must be changed.
Final gear bearing
case shim clearance
0.10 mm (0.004 in)
List of shims @ (Refer to page 4-37)
Part No. Shim thickness
27327 - 34200 0.35 mm
27327 - 34210
0.40 mm
27327 - 34220 0.50 mm
27327 - 34230 0.60 mm
BACKLASH
• Install the backlash measuring tool on the drive
bevel gear coupling, and set-up a dial gauge as
shown in Fig.
09924- 34510
Final gear backlash
(Drive side)
Backlash measuring tool
(27- 50 mm)
0.03 - 0.64 mm
(0.001 - 0.025 in)
• Adjust the dial gauge so that it touches the
backlash measuring tool arm at the mark; hold
the final driven bevel gear securely, and turn the
final drive bevel gear coupling slightly in each
direction, reading the total backlash on the dial
gauge.