Suzuki Madura GV700GL Service Manual page 124

4-9 SHAFT DRIVE
• Install the bearing onto the secondary driven
bevel gear shaft by using the special tool.
09913- 84510
Bearing installer
CAUTION:
When replacing the secondary driven bevel
gear, replace the secondary drive bevel gear
also, as they must be replaced together.
• Install the spacer onto the secondary driven
bevel gear shaft first and then the shims. Use the
removed spacer and shims.
NOTE:
Coat the bearings with hypoid gear oil before
install in g.
• Install the secondary driven bevel gear shaft into
the secondary driven bevel gear housing and
then the coupling, washer and nut from the
other side.
CAUTION:
Always use a new nut.
• Tighten the nut to the specified torque by
using the special tool and torque wrench.
Tightening torque
09920- 80710
90-110 N-m
(9.0 - 11.0 kg-m)
(65.0- 79.5 lb-ft)
Secondary driven gear
coupling holder
**
"BEARING PRE-LOAD ADJUSTMENT" is
necessary. (See page 4-10)