Suzuki Madura GV700GL Service Manual page 128

4-13 SHAFT DRIVE
• Rotate the secondary driven bevel gear coupling
several turns in both directions.
• Remove the secondary drive bevel gear from the
secondary gear case, and observe the tooth
contact pattern made in the dye or paste.
• Compare the tooth contact pattern to the
examples as shown in
CD,®
and @.
• If tooth contact is found to be correct, go the
Final Assembly sub-section, and complete.
• If tooth contact is found to be incorrect, the
shims of the secondary drive bevel gear and
secondary driven bevel gear must be changed,
tooth contact should be re-checked until correct.
CAUTION:
After the tooth contact adjustment is made,
the backlash must be re-checked, as it may
change. Refer to the backlash checking
sub-section, and readjust until both backlash
and tooth contact are correct.
Tooth contact
Shim adjustment
Contact at tooth
Decrease thickness
top
CD
of shims ® or @
Contact at tooth Increase thickness
roof@ of shims ®or @
List of shims @ (Refer to page 4-16)
Part No. Shim thickness
24945 - 05AOO - OAO
0.30 mm
24945 - 05AOO - OBO
0.35 mm
24945 - 05AOO - OCO 0.40 mm
24945 - 05AOO - ODO
0.50 mm
24945 - 05AOO - OEO 0.60 mm
®CORRECT
@INCORRECT (Contact at tooth roof)
List of shims ® (Refer to page 4-16)
Part No.
Shim thickness
24934- 05AOO- OAO
2.90 mm
24934 - 05AOO - OBO 3.00 mm
24934 - 05-AOO - OCO 3.10 mm
24934- 05AOO- ODO 3.20 mm
24934 - 05AOO - OEO 3.25 mm
24934- 05AOO- OFO 3.30 mm
24934 - 05AOO - OGO 3.35 mm
24934 - 05AOO - OHO 3.40 mm
24934 - 05AOO - 010 3.45 mm
24934- 05AOO- OJO 3.50 mm
24934- 05AOO- OKO 3.55 mm
24934 - 05AOO - 0 LO 3.60 mm
24934 - 05AOO - OMO 3.65 mm
24934 - 05AOO - ONO ·
- .
3.70 mm
24934- 05AOO- OPO 3.75 mm
24934 - 05AOO - 000 3.80 mm
24934 - 05AOO - 0 RO 3.90 mm
24934 - 05AOO - OSO
4.00 mm
24934 - 05AOO - OTO 4.10 mm