Cylinder Head - Suzuki Madura GV700GL Service Manual

REAR CYLINDER
• Repeat the above procedure when reinstalling
the rear cylinder head, camshafts and camshaft
journal holders.
NOTE:
Damage to head or cam journal holder thrust
surfaces may result if the cam journal holders
are not drawn down evenly.
• When adjusting the valve timing for rear cylin-
ders, the same procedures are applied as those of
the front cylinders.
• First install the intake camshaft which is identi-
fied by letter "G" and engage it with the timing
chain.
• Count out 18 pins and engage the 18th pin with
the index mark on the sprocket of the rear
exhaust camshaft "H".
• Tighten the cylinder head bolts, camshaft
journal holder bolts and head nuts to the speci-
fied torque.
Initial Final
Camshaft 15 N-m
23-27N-m
journal (1.5 kg-m) (2.3- 2.7 kg-m)
holder bolt ( 11.0 lb-ft) (16.5- 19.51b-ft)
Cylinder 35 N-m 46-51 N-m
head
(3.5 kg-m)
(4.6- 5.1 kg-m)
bolt (25.5 lb-ft) (33.5- 37.0 lb-ft)
Cylinder
8-12 N-m
head nut
(0.8 - 1.2 kg-m)
(6.0 - 8.5 lb-ft)
Front
rp(
lw
NOTE:
ENGINE SERVICING 3-78
® Smaiii.D.
washer
0 Longer bolt
When reinstalling the cyJinder head bolts,
lightly apply engine oil to the bolt thread.