Suzuki Madura GV700GL Service Manual page 138

4·23 SHAFT DRIVE
• Using the special tools,(!),@ and@, remove the
bearing plate with the bearing.
CD
09924- 74570
Final driven gear bearing
installer and remover
®
09924- 74510 Handle
®
09924- 74520
Oil seal installer and
remover
• Remove the final driven bevel gear from the
final gear case.
• Remove the shims which are located at both
sides of final driven bevel gear.
• Remove the bearing retainer by removing the
three screws.
• Remove the final drive bevel gear assembly from
the final gear case.
• To remove the needle roller bearing of final
driven bevel gear and the oil seal from the final
gear case, use the special tools,@ and @.
@
09941 - 64510
Bearing and oil seal
remover
@
09930 - 30102
Sliding shaft
CAUTION:
The removed bearing and oil seal should be
replaced with new ones.