Suzuki Madura GV700GL Service Manual page 81

3·51 ENGINE SERVICING
Unit: mm (in)
Service Limit Drive plate Driven plate
Thickness 2.15 (0.085) -
Distortion - 0.1 (0.004)
Claw width 15.0 (0.59)
-
CLUTCH SPRING FREE LENGTH
Measure the free length of each coil spring with
vernier calipers, and compare the elastic strength of
each with the specified limit. Replace all the
springs if any spring is not within the limit.
Clutch spring free length
Service Limit 34.0 mm (1.34 in)
CLUTCH BEARING
Inspect clutch push piece bearing for any abnor-
mality, particularly cracks, upon removal from the
clutch, to decide whether it can be reused or
should be replaced.
Smootn•"' engagement and disengagement of the
clutch depends much on the condition of this
bearing.
NOTE:
Thrust washer is located between the pressure
plate and thrust bearing.
SLEEVE HUB SPRING WASHER
• Install the spring seat, spring, and driven plate
in the clutch sleeve hub. Check that these three
parts are positioned correctly as illustrated.
While holding the driven plate with pliers, install
the piano wire clip.
NOTE:
Always use a new piano wire clip.
Checking claw width