Suzuki Madura GV700GL Service Manual page 227

9-3 CHASSIS
AXLE SHAFT
Using a dial gauge, check the axle shaft for runout
and replace it if the runout exceeds the limit.
09900 - 20606
09900-20701
Service Limit
WHEEL RIM
Dial gauge (1/100)
Magnetic stand
(Not available in USA)
0.25 mm (0.01 0 in.)
Make sure that the wheel run out checked as shown,
does not exceed the service limit. An excessive
runout is usually due to worn or loose wheel
bearings and can be reduced by replacing the
bearings. If bearing replacement fails to reduce the
runout, adjust the tension of the spokes and, if
this proves to be of no effect, replace the wheel
rim.
Service Limit
(Axial and Radial)
SPOKE NIPPLE
2.0 mm (0.08 in)
Check to be sure that all nipples are tight, and re-
tighten them as necessary by using 6 mm open end
wrench.
Tightening torque
TIRE
4-5
N·m
(0.4- 0.5
kg-m)
(3.0- 3.5
lb-ft)
For proper braking and riding stability, the tire
should have sufficient groove depth from the tread
surface. If the groove depth, measured as shown in
the figure, reaches the wear limit, replace the tire.
Service Limit
Front
1.6 mm (0.06 in)
Rear
2.0
mm
(0.08
in)