Proline Prosonic Flow 93 FOUNDATION Fieldbus
Endress+Hauser
3.15
Post-installation check
Perform the following checks after installing the measuring device on the pipe:
Device condition and specifications
Is the device damaged (visual inspection)?
Does the device correspond to specifications at the measuring point, including
process temperature, ambient temperature, measuring range, etc.?
Installation
Are the measuring point number and labeling correct (visual inspection)?
Process environment / process conditions
Have the inlet and outlet runs been observed?
Is the measuring device protected against moisture and direct sunlight?
Installation
Notes
–
ä 120
Notes
–
Notes
ä 12
–
57