Endress+Hauser Proline Prosonic Flow 93 Operating Instructions Manual page 87

Proline Prosonic Flow 93 FOUNDATION Fieldbus
Endress+Hauser
!
Note!
• The display returns to the cell SETUP COMMISSIONING (1002) if you press the X key combination during
parameter interrogation. The stored parameters remain valid.
• The "Commissioning" Quick Setup must be carried out before one of the Quick Setups explained below is run.
m
The "DELIVERY SETTINGS" option sets every selected unit to the factory setting.
The "ACTUAL SETTINGS" accepts the units you configured beforehand.
n
Only units not yet configured in the current Quick Setup are offered for selection in each cycle. The volume unit is
derived from the volume flow unit.
o
The "YES" option remains visible until all the units have been configured.
"NO" is the only option displayed when no further units are available.
p
The "automatic parameterization of the display" option contains the following basic settings/factory settings
YES Main line = volume flow
Additional line = totalizer 1
Information line = operating/system condition
NO The existing (selected) settings remain.
q
The execution of other Quick Setups is described in the following sections.
Commissioning
87