Endress+Hauser Proline Prosonic Flow 93 Operating Instructions Manual page 25

Proline Prosonic Flow 93 FOUNDATION Fieldbus
!
!
Endress+Hauser
Connecting the PC to the plant asset management tool
A personal computer is connected to the FieldCare plant asset management tool via the service
interface FXA 193. The service interface FXA 193 is connected to the service connector of the
transmitter.
A
Fig. 18: Connecting a PC with the FieldCare operating software
a Service adapter for connecting service interface FXA193
Switching on the measuring device
Perform the post-connection check as specified in the checklist  ä 68.
1.
2. Switch on the supply voltage for the device. The device performs internal test functions.
Various messages appear on the display.
3. Normal measuring mode commences. Various measured value and/or status variables appear
on the display (HOME position).
Note!
If startup fails, an appropriate error message is displayed, depending on the cause  ä 96.
Reading off the installation distances via FieldCare
Note!
The following section only illustrates the functions necessary for clamp-on and insertion type of
mounting.
Reading off installation distances via FieldCare for clamp-on type of mounting
1. Enter or select installation-specific values or the values specified here.
2. Read off the installation distances necessary for mounting.
Basic function

Sensor data K1/K2
Clamp-on  Measurement
1 or 2  Sensor configuration
A

Sensor parameter

Sensor type
– – – –
+ + + +
1 2 20 21 22 23 24 25 26 27
= Number of traverses
Installation
a
A0011365
25