Configuring An Additional Routing Metric; Configuring Ripng Route Summarization; Advertising A Default Route - HP 3600 v2 series Configuration Manual

Define an IPv6 address prefix list before using it for route filtering. See the chapter "Routing policy
•
configuration" for related information.

Configuring an additional routing metric

An additional routing metric can be added to the metric of an inbound or outbound RIP route.
The outbound additional metric is added to the metric of a sent route. The route's metric in the routing
table is not changed.
The inbound additional metric is added to the metric of a received route before the route is added into
the routing table, so the route's metric is changed.
Follow these steps to configure an inbound or outbound additional routing metric:
To do...
Enter system view
Enter interface view
Specify an inbound routing
additional metric
Specify an outbound routing
additional metric

Configuring RIPng route summarization

Follow these steps to configure RIPng route summarization:
To do...
Enter system view
Enter interface view
Advertise a summary IPv6 prefix

Advertising a default route

Follow these steps to advertise a default route:
To do...
Enter system view
Enter interface view
Advertise a default route
NOTE:
With this feature enabled, a default route is advertised through the specified interface regardless of
whether the default route is available in the local IPv6 routing table.
Use the command...
system-view
interface interface-type interface-number
ripng metricin value
ripng metricout value
Use the command...
system-view
interface interface-type interface-number
ripng summary-address ipv6-address
prefix-length
Use the command...
system-view
interface interface-type
interface-number
ripng default-route { only |
originate } [ cost cost ]
267
Remarks
––
––
Optional
0 by default
Optional
1 by default
Remarks
––
––
Required
Remarks
––
––
Required
Not advertised by default