Configuring Bfd For Ospf - HP 3600 v2 series Configuration Manual

Destination: 4.4.4.4/32
Protocol: OSPF
Preference: 10
IpPrecedence:
NextHop: 13.13.13.2
BkNextHop: 12.12.12.2
RelyNextHop: 0.0.0.0
Tunnel ID: 0x0
BKTunnel ID: 0x0
State: Active Adv
# Display route 1.1.1.1/32 on Switch D. You can find the backup next hop information.
[SwitchD] display ip routing-table 1.1.1.1 verbose
Routing Table : Public
Summary Count : 1
Destination: 1.1.1.1/32
Protocol: OSPF
Preference: 10
IpPrecedence:
NextHop: 13.13.13.1
BkNextHop: 24.24.24.2
RelyNextHop: 0.0.0.0
Tunnel ID: 0x0
BKTunnel ID: 0x0
State: Active Adv

Configuring BFD for OSPF

Network requirements
As shown in
other at the network layer.
After the link over which Switch A and Switch B communicate through a Layer 2 switch fails, BFD can
quickly detect the failure and notify OSPF of the failure. Switch A and Switch B then communicate through
Switch C.
Tag: 0
Tag: 0
Figure 48, OSPF is enabled on Switch A, Switch B and Switch C that are reachable to each
Process ID: 1
Cost: 1
QosLcId:
Interface: Vlan-interface200
BkInterface: Vlan-interface100
Neighbor : 0.0.0.0
Label: NULL
BKLabel: NULL
Age: 00h01m27s
Process ID: 1
Cost: 1
QosLcId:
Interface: Vlan-interface200
BkInterface: Vlan-interface101
Neighbor : 0.0.0.0
Label: NULL
BKLabel: NULL
Age: 00h01m27s
124