HP 3600 v2 series Configuration Manual page 337

[SwitchB-Vlan-interface10] bfd detect-multiplier 6
Verify configuration.
4.
The following operations are made on Switch A. Operations for Switch B are similar and are not shown
here.
# Display the BFD information of Switch A.
<SwitchA> display bfd session
Total Session Num: 1
IPv6 Session Working Under Ctrl Mode:
Local Discr: 1441
Source IP: FE80::20F:FF:FE00:1202 (link-local address of VLAN-interface 10 on
Switch A)
Destination IP: FE80::20F:FF:FE00:1200 (link-local address of VLAN-interface 10 on
Switch B)
Session State: Up
Hold Time:
# Display route 2001:4::0/64 on Switch A, and you can see that Switch A and Switch B communicate
through the Layer-2 switch.
<SwitchA> display ipv6 routing-table 2001:4::0 64 verbose
Routing Table :
Summary Count : 2
Destination : 2001:4::0
NextHop : 2001::2
IpPrecedence :
RelayNextHop : ::
Neighbor : ::
Interface : Vlan-interface10
State : Active Adv
Tunnel ID : 0x0
Age : 4538sec
Destination : 2001:4::0
NextHop : 2001:2::2
IpPrecedence :
RelayNextHop : ::
Neighbor : ::
Interface : Vlan-interface11
State : Invalid Adv
Tunnel ID : 0x0
Age : 4515sec
# Enable BFD debugging on Switch A.
<SwitchA> debugging bfd scm
<SwitchA> debugging bfd event
<SwitchA> debugging isis event bfd
<SwitchA> terminal debugging
Init Mode: Active
Remote Discr: 1450
/
325
Interface: Vlan10
PrefixLength : 64
Preference
QosLcId
Tag
ProcessID
Protocol
Cost
Label
PrefixLength : 64
Preference
QosLcId
Tag
ProcessID
Protocol
Cost
Label
: 15
:
: 0H
: 0
: ISISv6
: 20
: NULL
: 15
:
: 0H
: 0
: ISISv6
: 30
: NULL